Perfactory® PixCera

The PixCera 3D Printer is designed to support Rapid Direct Manufacturing with a low cost and high resolution solution. The PixCera is a great 3D printer machine for the small lab and can print up to 20 copings, crowns and up to 7 unit bridges in wax-based Press-E-Cast in under 2 hours. The wax parts are designed for speed investment casting, allowing for a fast one hour burn-out cycle. With a small footprint, the PixCera is economically designed to fit into a small area. It is office friendly and has a low power consumption. The PixCera can operate unattended with maximum reliability.  With the UV option, the PixCera can also print E-Dent 3D printer materials.

Benefits:

• Easy handling through pre-adjusted material modules.
• Very few moving parts and minimal consumable components guarantee a strong and reliable system.
• Minimized components make the system user serviceable.
• Post-processing is clean and simple due to near 100% photo cure during the build process.
• A choice of high quality 3D printer materials are readily available.
• On-site RM adapted for local production demands.
• Fully cured models are chemically safe.

• E-Dent – Temporaries
• E-Partial – Partials
• Press-E-Cast – Waxups
• E-Shell® 200, E-Denstone – General Use

• Build Envelope: 2.36” x 1.71” x 3.94” (60 x 45 x 100 mm)
• Projector Resolution: 1400 x 1050 pixels
• Native Pixel Size: 0.0017” (43 µm)
• Dynamic Voxel Resolution in Z**: 0.0010” – 0.0014” (25 µm – 35 µm)

*Specifications subject to change without notice.
**Material dependent